JTAG cable for connection to a standard JTAG 20-pin 2.1.65 V to 3.6 V application voltage support on the JTAG/SWD interface and 5 V tolerant inputs.JTAG/serial wire debug (SWD) specific features:.SWIM flat ribbon with a standard ERNI connector at one end SWIM cable with two 4-pin, 2. connected to the target board by two different cables, depending on the connector available. SWIM cable for connection to an application with pin headers or 2.54 mm pitch connector For development of applications based on STM8 microcontrollers, the ST-LINK/V2 can be.SWIM cable for connection to an application with an ERNI standard connector Vertical connector reference: 284697 or 214017 Horizontal connector reference: 214012 STLINK / V2 driver KEIL MDK (4.60) development environment (and other common development environments) IAR STM8 (1401) development environment (and other.SWIM programming speed rates: 9.7 kbyte/s in low-speed, 12.8 kbyte/s in high-speed Projected ridership including downtown Redmond extension: 43,000 52,000 daily riders by 2026.SWIM low-speed and high-speed modes support.ST-LINK is a USB device and has to be connected to a PC host. 1.65 V to 5.5 V application voltage support on the SWIM interface The ST-LINK 1 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families.USB 2.0 full-speed compatible interface.Temperature, Humidity, Pressure, Gas, Environment.Drag Chains, Heat Shrinks, Cable Protectors.
